zdravo ja sam Željko i skoro sam kupio helikopter kds 450 s i pokusavam da letim sa njim ali su mi rekli da prvo naucim na simulatoru,tako da on stoji a ja nikako da pokrenem simulator i pocnem da vezbam,u pitanju je simulator AeroFly Professional Deluxe a stanica je od kds 450 s e sad na njoj pise 2.4 ghz spread spektrum tehnology K-7X i nece pa nece nikako preko kabla da se usaglasi i da radi komp vidi stanicu kao PPM ali sta god da pokusam u control panelu da vidim da li radi ne reaguje onaj krstic kada pomeram rucice.da li treba da imam neke drajvere za stanicu ,dali nije dobar simulator ,kabal mi je nov ide direkno iz usb u stanicu, ali nece pa nece,MOLIM ZA POMOC
Zeljko,
ukljuci PPM mod na stanici !
Step 1. Change To New Model
Hold Both The Up & Down Buttons, Now Turn On The Transmitter.
Now You Should See “S2 HP3” On Your Screen.
Navigate to “S1” Using the Up Button.
Change The Model Using The “inc Or dec” Buttons.
Navigate To “S2” To Save Settings
You Have Now Completed Selecting A New Model
Step 2. Change Your New Model To AirPlane Mode
PLEASE NOTE. This Is Important To Change Even If you Will Be Flying
A Helicopter OnThe Simulator
Hold Both The Up & Down Buttons, Now Turn On The Transmitter.
Now You Should See “S2 HP3” On Your Screen.
Change The Setting To “AP” Using The “inc Or dec” Buttons.
Navigate To “S2” To Save The New Setting & Turn Off Controller.
Your Controller Is Now Set To Airplane Mode Ready For The Simulator.
Step 3. Turning On The Transmitter In “PPM” Mode
Hold Both The “Inc & Dec” Buttons, Now Turn On The Transmitter.
Your Controller Should Now Be Beeping Rapidly & You should See
“7c - 2.10”
Now Release The “Inc & Dec’ Buttons, Your Screen Should Now Show
“PP” Then The Voltage Of The Batteries In Your Controller.
The Red Power Light Should Be On, RF Should Be Off
Transmitter Is Now Ready To Be Used With The Simulator.
You Must Repeat Step 3 Every Time Your Wish To Use The K-7x With
The Simulator, If You Don’t Your Controller Will Turn On In “PCM”
