Pokusaj na sledeci nacin: (neka me neko ispravi ako gresim, ali mislim da je ovo univerzalno programiranje modelcraft esc-a)
• Switch off the control unit. Hold down the small setup button(on esc) left of the on/off switch
(don't release!) and switch the control unit switch to the "ON" position.
• When the blue LED on the control unit is lit, release the setup button.
• Move the gas/brake lever to full speed setting.
• The red and the yellow LEDs flash and then stay lit, a beep tone can be heard, the full speed setting is
saved.
The peeping is caused by a short activation phase of the Brushless Motors. Depending on
the motor, this peeping sound can be very soft, perhaps not audible at all. Please then pay
attention to the dial of the LED on the cruise control.
• Now move the gas/brake lever to full reverse setting.
• The red and the blue LEDs flash and then stay lit, two beep tones can be heard, the full reverse setting
is saved.
• Now release the gas/brake so that it sits in the neutral position.
• The red and the green LEDs flash and then stay lit, three beep tones can be heard, the neutral position
setting is saved, all LEDs cease to be lit.
• Switch the controller off, the programming to the remote control is complete.
If you always use the same remote control, the programming of the settings on the speed
lever for your remote control need only be carried out once and/or when you have made
changes to the setup of your remote control
